Tag Archives: portable

Review – Zebra SL-F1 Collapsible Pen

Posted on by
Reply

Earlier this year, my Fischer Space Pen Stowaway finally had the accident I was worried it might all along (the two halves of the pen became separated, and now I only have a cap). So, I needed to acquire some new small, daily carry pen. The choice wasn’t particularly difficult, my go-to ballpoint pen company, Zebra, has been making a collapsible pocket pen for some time and previously I simply never had an excuse to buy it. But, now that it’s in my hands, does it actually hold up?

When retracted the pen is absolutely tiny at just over 3¼ inches long. The rear part of the pen is a cylinder 7mm in diameter and just under 2 inches long. At the top of this tube is a flat chrome finial with a simple chrome clip extending just beneath it. At the other end of the tube is a slight polished step-down that leads to a smaller tube, at the end of that is a similar step-down leading to a polished metal cone. Grabbing the smaller tube and pulling forward slides it out from the larger tube about an inch. This action also retreats the cone a quarter inch into the pen and pushes the point of the pen out of the end (leaving you with an overall length of 4¼ inches). Both of these cylinders are constructed of metal with a matte black finish applied, and the only markings are the word “zebra” written in silver near the bottom of the larger barrel.

The retraction and extension method is a bit clunky and sticky, but it is very solid feeling and doesn’t show signs of failing anytime soon. The only potential problem I can see is that you need to be holding the tube that extends in order to write or the whole thing collapses back up again. The fine, .7mm ballpoint tip is, like all of Zebras refills incredibly smooth for a ballpoint while still having minimal skipping issues and providing a consistent and dark line (it writes almost identically to their standard refills for the “F” ballpoint series, but is a smaller, specialty refill). The extension of the pen is just enough to place it in the crook of most hands, allowing for it to be supported when writing, but the barrel/grip section, even for a lover of thin pens like myself, is small enough that your hand will cramp up over longer writing sessions (but this pen obviously wasn’t meant for that).

If you’re looking for a pen that maximizes space while still being rugged and usable, this is a definite winner. The metal construction is hardy, while the extending feature is handy. It is easy to refill by screwing out the front cone (preferably when collapsed) but remains safely in one piece throughout normal use. The clip is very grippy and sturdy while not being sharp or prone to rip fabric, and its situations so near the top allows for deep carry with very little sticking out above to get caught or seen (though this is actually a problem for where I use it, as I have a hell of a time getting it out of the loop I’ve stored it in on my belt pouch. Something like that shouldn’t be an issue for most people). The writing is very nice and smooth with a permanence suitable to most people even though it can’t write upside down or underwater. And the price, while certainly higher than most ballpoint pens, is not going to break the bank.

Review – Tombow Airpress

Posted on by
Reply

My Tombow Airpress was presented to me in Japanese packaging, and, as such, I had no idea what it was supposed to do. Upon careful inspection of the pictograms, I came to a conclusion that was reasonably close to the correct answer of: it is a pressurized ink pen (so it can write upside down or underwater and such {think: space pen}), but it only gets pressurized when you depress the click mechanism. If or why this would be an advantage over regular pressurized systems I do not know, but the pen does come with a set of other features to make it more usable in the rugged outdoors and whatnot, so maybe you’ll get a greater value out of it. I’m probably not the target market here (my pens lead a very relaxed life), but let’s take a look anyway.

The body of the Airpress is cigar-shaped, with a rubber coating, and quite short at less than 5”. An eye-shaped indent in the middle of the pen and six plastic flutes on the section expose the inner mechanism so that you can see a little bit of what’s going on inside. At the front, there’s a removable cone (which is where the pen gets refilled) that tapers down to where the ballpoint gets exposed. Up near the back is a plastic area, attached to which is a weird-looking wire clip (with a plastic end for extra grip), and protruding from it is the click-button. Sitting opposite the clip is a clear-plastic lanyard hole. The identifying markings are hard to find, with “Airpress” being molded into the rubber and “Tombow” “Japan” very minute in the plastic around the mechanism. Still, there is enough there for refills or replacement if you need it.

The tip is a little finer than the average medium ballpoint and writes smoothly enough, though I do find it has a problem with blobbing or bits of dried ink on the end like many of the pressurized ink cartridges. It is indeed capable of writing upside down (or without gravity) and underwater (which also proves that the ink is waterfast) with no noticeable effects on performance. The body is rugged and tough (though I don’t put my pens through terribly destructive situations) and the rubber coating allows you to maintain a solid grip throughout use. The clip is quite grippy, with the plastic attachment having several ridges that catch as it clips, and the wire design allowing it to open to almost a 45-degree angle without deforming or breaking. (I haven’t “tested” the lanyard hole, but it seems to be fine)

Everything about this pen is pretty solid. It’s easy to write with, easy to hold (it’s quite chunky and a little thicker than I like my pens, but some people prefer that and it’s better for the use case of this pen in particular), and well built. The clip and the click mechanism are both satisfying to use and the rubber is solid while lacking that sticky-feeling rubber can sometimes have. All of this comes in a very portable package at a decent price (cheaper than your average Fischer Space Pen), which makes it something ideal to look at for someone in one of the various “rugged” professions or as a reliable EDC (everyday carry) pen.

Review – Moleskine Softcover Pocket Book

Posted on by
Reply

Perhaps I lose a little bit of “reviewer credibility” when I say that my main notebooks for years have been Moleskine ones (specifically hardcover pocket and large). I know they’re not the best notebooks in the world, and I am phasing them out of my routine (since I’ve mostly stopped with specific daily uses, and uniformity is less of an issue for a while) but they are widely available, simple, and consistent books of decent quality. That being said, the ones I use have always been hardcover, and at this (192 page) size I prefer the rigidity of a hard-back, but am I being unfair to the softcover books?

First off, all Moleskines come with a wrap-around paper “package”, and I’ll admit, my book is old enough I don’t know where it went, but I assume now they have updated it to the same useless “reusable” packaging that has vague blanks about travel to fill in if that floats your boat. The cover itself is a nice, flexible (black) pleather wrapped around the book in a single piece. On the back “Moleskine®” is stylishly stamped near the bottom and the elastic band is attached at two points. The cover has a pleasant texture that is relatively even and doesn’t scratch easily, but does show the binding and attachment points underneath and impressions from the elastic closure. It also easily divots and is structurally weak at the corners.

Inside is the same-old Moleskine stuff: a “belongs to” page at the front, a cheap ribbon bookmark (mine unravel more and more often these days), and a sturdy pocket in the back that I’ve never personally found a use for. The paper is a pleasant off-white with a nice smooth (but not slick) texture that takes ballpoints and pencil very well (if you’re using it one sided {so no 192 pages, as advertised}). With anything more significant you get a lot of show-through, and with fountain pens or markers you’ll get bleed-through. I find it pleasant to write or sketch on, and the fact that it’s acid-free means your work is safe over time, but it is fairly fragile stuff (I wouldn’t erase too much).

In the end it’s what I expected, the same Moleskine quality with a cover that is more easily bent and damaged (I do care about how my books look). It will probably hold up to most types of use, but it won’t look pretty at the end (the pocket at the back does mean it maintains support for off-the-table use, though). It’s a fine notebook, with decentness all-around, from page feel to binding, but it seems like less and less of a deal as things progress. One can find books at WalMart (potentially of dubious archival-quality) that do the same things cheaper these days, and they might not have the same quality control, but they are so much cheaper. I like the Moleskines for their ubiquity and uniformity, but they’ve always been overpriced, and this cover just doesn’t do it for me.

Review – Swingline Tot (Mini) Stapler

Posted on by
Reply

I’ve been using an old Swingline CUB stapler at my desk for years now. The combination of small size and standard staples makes it perfect for me, a person who doesn’t have to staple often. I also have the super small Tot-50 stapler in my pencil case, and while the size is good it does use a different type of staple to most other staplers. But now Swingline has a middle ground even between those two with the Tot, a stapler that is just about as small as you can get while still using regular sized staples. But how useful could that be?

The Tot is about 2½” in total length, 1¾” tall, and 1¼” wide. These measurements are a bit larger than they could have been due to the rounding of the stapler body; there are no sharp edges on it. At the back there is a curved piece of metal sticking out to serve as a staple remover. It works fairly well, though unlike the standard “jaw” type it does have the tendency to fling used staples across the room. On the top and bottom of the main body there are relatively comfortable divots in which to place your fingers when stapling. And the entire thing is a sort of teardrop shape, narrow in the back and widening near the front before suddenly dropping off.

Underneath is a small rubber “plate” (for lack of a better word) covering with a handy mark representing staples stamped into it (in the previously mentioned divot), though if I didn’t know they were supposed to be staples I wouldn’t have figured it out. Peeling this back from the nice little nail nick (it’s held in place with tabs in slots) reveals a small storage compartment with enough space for a regular block of standard sized staples, and enough space for (someone with smaller) fingers to get in and grab it. Below these staples is the general information about the product, save for the brand name which is proudly displayed on top. This rubber piece is fully removable, though it is a bit finicky to get it past the staple remover on the back both when getting it on and off. I can also say, from a spill on my desk, that the rubber seals well enough to be water resistant (but I wouldn’t count on it).

As with most Swingline products stapling is as easy as can be. There’s a surprisingly good amount of leverage in this design and it connects pages cleanly and neatly together. Its use of regular sized staples and a mouth about as wide as your standard desk stapler means that it will basically perform the same function, with its only limiting factor being capacity (and durability since it is made of mostly plastic and most staplers are metal). My only general complaint is the top; it’s quite easy to open and hinges back far enough to make loading a breeze, but the tab that holds it in place when it’s supposed to be locked down is very weak and I’ve found it to pop open with slight provocation, or even without provocation at times. And that’s slightly worrying: I don’t want staples everywhere. But the spring holding it down is fairly strong, and if kept on the desk or in a case this shouldn’t be a problem.

So, if you’re not one that staples often, have limited desk space, or want to carry a stapler with you but not special staples (but maybe with a bag or case) this little guy will work great. It’s small, easy to use, and gets the job done. It isn’t as durable as the larger versions (or its metal predecessor the Tot-50), but with care it will work for a long time (but maybe not as long as my CUB) and for how inexpensive they can be I’d say they’re definitely worth it (and they come with a box of staples, which is cool).