Review – Zig Millennium 005 Technical Pen

There are a lot of technical pens out there, and I’ve only looked at a few. Today I’m going to try and remedy that a little bit by doing a review of the Zig Millennium technical pen, specifically the black 005 version.

20141216-235803

The pen body is a bit odd. The bottom is a small, rounded piece of plastic. The barrel is silver and covered in writing. All necessary information is printed in several languages. The cap is nothing really special either: the top is flat with the tip size on what looks like a black plastic cutaway; the clip is simple, with a rounded end similar to a Pilot Precise or Uni-ball Vision. Interestingly enough, it says to keep the pen horizontal, but gives one a pocket clip. It’s the section of the pen that’s strange: it’s very small and nubby, it rounds off quite quickly and the ridges used to keep the cap in place are quite noticeable. It terminates rather abruptly into a metal end that leads to the tip. I’m not sure if one is supposed to hold the slightly uncomfortable section when writing or move back on the pen and place the fingers over the written portions of the pen, which I can feel the ink is raised up on, and will likely rub off quickly.

20141216-235811

On to the tip. It produces a very thin line, around the same width, but perhaps a bit wider than other brands of the same size, though that may just be the paper being used. The ink is archival quality (haven’t tested) and waterproof (have tested, is quite!) though that is to be expected from a pigmented ink. The black is quite black, and a cool black, which is nice, as many blacks tend to be warm. Writing is smooth and there are no skips or bumps with a good tip, though it will wear out after some time.

Overall it’s a good little pen, and quite comparable to the other technical pens in terms of both quality and price. I can’t speak for whether or not the rest of the line is wider than its counterparts from other brands, but that might be something to consider when purchasing. Otherwise, I’d say it’s almost entirely an æsthetic and comfort choice for the user.

Review – Sakura Micron 005 Technical Pen

Ah, Microns, the main technical pen of the trade. This one specifically is the 005 (.2mm) black version. The body is easy to hold. The finish is glossy, but grip-able. It is just long enough to be comfortable in the hand and is a nice comfortable plastic. The nib size is neatly marked on the side and top, making it easy to find the right pen for the job. After much use however, the makings on both the side and top fade away, with the top going first.

The nib is very thin, good for fine detail work and writing. It does bend easily and one should be careful about how much pressure is applied when using it. When the correct amount of pressure is applied the line is very smooth and even. The ink itself is a nice deep black that is resistant to bleeding when wet but does fade when an eraser is rubbed over it. Other then that minor fading the Pigma ink is very reliable. The ink does not bleed through thin paper and mark other sheets below it.

After heavy use the markings on the pen do rub off as mentioned. The nib begins to wear down and the metal past it begins to mark the paper. The lines begin to become jittery and inconsistent. But that is after a long and useful life. The amount of time it takes to wear the pen down to that point is incredible. And it more then makes up for its price.

The Micron is the premiere technical pen (almost) and does its job incredibly well. They are expensive but amazing (in my opinion) and at the very least write well. And the amount of time that they last easily allows for them to be replaced when they begin to show signs of wear.