Review – INC PenMark Permanent Markers

As someone who bolts to the stationery section of every store I enter, every once in a while I just have to dive into one of the budget options there (I say that like cheap crap isn’t something that I have innumerable piles of). And if you do this at Dollar General you’re very likely to end up with something made by INC, a brand I’ve looked at before that produces writing utensils that function. Is their current foray into permanent markers, the PenMark, any good?

The bodies are a simple design. The body is a cylinder with a foil label that has minimal information printed on it. The cap mostly continues this cylindrical motif until its end, when it slants off at a slight angle. The clip is plastic and unsurprisingly molded into the cap (for safe keeping). At the other end there is a hexagonal step-down for posting, which the cap nicely clicks onto. Underneath the cap is a series of 3 step-downs that lead to a metal tube with a small, stiff felt-tip.

The performance is as to-be-expected. They smell like permanent markers, and the line stays like permanent markers. The ink causes a lot of bleeding and feathering, even on high-quality paper; the result is a line considerably thicker than the “ultra fine point” stated on the package. The colors are all pleasant and readable, with the exception of yellow, which is, like most yellow, essentially useless, and they do stick to the paper and remain vibrant once applied. Water has no discernable effect on the markings, but alcohol does start to break down the dye/pigment. The lines will break down and feather under regular rubbing alcohol, and bleed through increases tremendously, but during my tests the lines actually remained legible.

If you’re looking for an assortment of permanent marker colors on the cheap, these technically fulfill that requirement. The bodies are cheap, the nibs are brittle, the ink bleeds and is more-than-likely not archival quality. But they provide a mark that is suitably permanent on household materials (paper, tin cans, and plastic containers; they will fade, but they will leave behind a water-resistant mark) in a skinny, portable body which fits anywhere your average pen will, with a clip that holds them in place.

Review – Rosetta 4- and 3-Pen Cases

Well, here’s a bit of a blast from my past. This product doesn’t seem to be available anymore, but it can now at least serve as a cautionary tale about getting what you pay for. I’m talking about Rosetta “leather” pen cases that came in both 3- and 4- slot sizes. I acquired these back when I didn’t have an adequate way to transport multiple fountain pens for use (I still don’t, but that’s because I won’t fork over the money for a good case) and these looked the part (they’re modeled after the Aston Pen cases) but were about a quarter the price; was there really any value there?

There isn’t much to describe about the look of the cases; each has a flat back that curls around the front at the top to form a protective flap which tapers to fit underneath a securing band. Stamped on the end of this “tongue” is the Rosette compass rose logo. Beneath the flap, a single piece of leather has been stitched down in several places to form either 3 or 4 rolls in which moderately sized pens can be inserted. Most of the surfaces have a smooth finish, but the unseen inside of these tubes is rough and unfinished feeling. Any edge where there would be leather is covered by a sealant-type goop.

From a design standpoint, there isn’t any real problem here, they hold pens well in a relatively compact space while providing protection. The real problem here is the longevity of the materials. The quality of the leather here is so poor that I’d question if it really was leather if not for the unfished inside of the rolls. And the finishing where the pens are held is thin and flimsy, it cracks and tears as the clips roll over it (and the space is small enough that most pens won’t fit inside with their clips not over the lip). And the whole thing is dry enough that it’s started to tear around the stitches with time. This isn’t damage from a dry environment (they’ve lived most of their life in a humid one) or that could have been prevented with an application of leather treatment (the outside is “finished” and hardly takes oil, besides it remains “supple” in that it can generally flex and bend without problems.). This is just a problem of poor materials, thin leather that wasn’t meant to last.

And so, as pen cases, they’re not really useful to me anymore. I know that with just a little more use they’ll come apart completely. And it would appear that this was a complaint others had, as I can hardly even find evidence that these guys were produced at one time, let alone still being sold. To me, they now serve as a reminder that there are budget options that are too good to be true, or aren’t’ really even worth the time looking at them.

Review – 25-Piece 1” Foam Brush Pack (Walmart)

I’ve been experimenting with some new (to me) “craft-y” techniques using paints and glues and such. Since I’m simply performing tests and I wanted an inexpensive way to acquire enough brushes for my purpose that didn’t necessarily need to stick around (not that foam brushes are known for quality or longevity). I quickly solved this problem at my local Walmart with their large pack of 25 one-inch foam brushes, and really there isn’t much to say beyond that description.

These brushes are a ¼” wooden dowel of the cheapest and lightest variety, with a poorly stamped “not for lacquer or shellac” “warning” on the side, that are attached by a plastic tongue to a sponge too delicate for kitchen work with a wedge on one end. Since the price is only a few dollars for two dozen, none of the materials here are of notable quality, but they do hold together long enough for one to get a few uses out of the things. I’ve found that after 3 glue applications (uses, not individual coats) and subsequent washes, these brushes begin to disintegrate, but this doesn’t affect how they work for at least a few more washes (and paint is obviously a little less harsh on them than glue). Even with foam brushes not being the highest quality at the best of times (where would one even acquire “high-quality” foam brushes?), these do seem to break apart fairly quickly, though not more than I would expect for the price.

I don’t see much of a reason to fuss about which foam brush set to pick up. The nature of foam is that they are inexpensive and allow for easy application of media in exchange for their own durability. This set is a cheap way to get a lot of brushes that will get the job done. If that’s what you need, they’re easy to find in most places.

Review – The Fine Touch 3-Brush Set (1-,2-, and 3-inch Flat)

I’m not a painter, or at least, not very often. Painting is expensive, time consuming, and space requiring. But nowadays there are budget products that are easing the “pain” a little bit. Bopping in to your local superstore and buying a set of brushes with a canvas or two for less than $20 is incredible. And “The Fine Touch” is one of the more visible brands (in my area at least) selling inexpensive painting supplies, like a set of three 1-inch increment synthetic brushes. Do they really work though?

Despite the common wisdom for years being that natural hair brushes are superior to synthetic nylon ones, they have made some improvement in quality over that time. I don’t know if the best synthetic brushes are better than the best natural ones, nor would I claim that these are better than any other brush, but I personally prefer the little extra “bounce” the nylon provides, and they’ve worked quite well for me over several painting projects.

The basic structure is the same as virtually all paint brushes: a wooden handle with information printed on it (varnished in this case) shaped like a paddle with a ferrule on one end that holds in a set of bristles. Conveniently, these also have a hanging hole at the end for easy storage. Everything about them is cheap; the wood is lighter than the bristles, with brush strokes in its finish and burs on the drill holes; the ferrules are a flimsily metal (which will likely rust) that has either cracked or slightly splintered each handle in the fastening process, and the bristles have a bad habit of falling out during the first few uses.

So obviously they aren’t “forever” brushes, but for what they are (cheap superstore brushes) they are entirely adequate to paint with. If you only have a couple projects, just want to get some paint down, or feel the need to ease into things you might not know you want to do “forever”, then they will work just fine for that. You won’t become a master using these, and you might get frustrated with the bristles in your paintings, but they work, and for just getting started, that’s enough.

Mini Review – Hobby Lobby Foam Core Board

Once in a while, every artist or crafter has to schlep down to the dollar store for some foam-core board. And inevitably when it cracks or tears one finds themselves wishing they’d gone for the slightly more expensive option. Could Hobby Lobby have been the savior in this scenario?

Perhaps; the generic foam core available from Hobby Lobby has a nice smoother (bordering on slick) finish over its cool white paper. The foam filling is rigid but still has a little bit of give. The whole assembly is lightweight and easy-to-cut; and, with a reasonably sharp blade, there is no tearing.

Depending on the store, this stuff is greater than or equal to the quality you will find in dollar or discount stores. It just feels nicer and holds up better. It may not be the best quality board in the world, but if you’re contemplating an upgrade and are unsure, consider yourself assured.