Tag Archives: quality

Review – Master’s Touch Palette Knife

Posted on by
Reply

I’ve been painting recently, and have a new appreciation for palette knives (foolishly I never used them before), both for controlling paint on a palette, and for painting. Unfortunately I’ve found no real resource that says if there are consistent sizes and shapes for palette knives, and I don’t believe there really is. So instead of this being a review of a specific size or shape of knife, this will be a general look at the quality of the Master’s Touch brand of inexpensive and easily accessible palette knives.

20150414-225713

The particular knife style here is slightly unconventional, and appears in the least amount of photos I see online, though it is the shape used by Bob Ross, so it’s got that going for it. The handle is a light, okay finished wood with a lanyard hole and the Master’s Touch logo imprinted on it. It’s sturdy enough and it works. Following that is what appears to be a “brass” “section” ring that is dented and losing its finish. It holds the blade in place, fairly sturdily, but also not centered. The blade is stainless steel, quite flexible and tapers down to a very usable edge. It is finished well enough, and doesn’t get thin enough to cut easily, but I suppose if one really tried they could make it dangerous. In some places the brushed finish isn’t nearly as well done, but these places don’t really matter in the scheme of things.

Overall it’s a nice introductory tool. It obviously has some quality control issues, but they aren’t major and don’t prevent the tool from functioning or make it dangerous. It’s inexpensive, and I would recommend it to anyone who isn’t sure if they really want to paint and are just trying to get into it, upgrading in the future is always possible and still isn’t a lot of money. And even if one doesn’t this tool will likely be able to last a painting lifetime.

Review – Pigma Brush

Posted on by
Reply

Do you like the flowing lines and moderation of a brush, but want the simplicity of a pen? The makers of Micron have a solution. The Pigma brush.

20121102-235927.jpg

 

 

The ink is the same as the Micron ink. It is a very deep black that applies smoothly to the page and rarely bleeds. It is waterproof and fadeproof archival ink. It marks just as well or better than any pen around.

 

The body of the brush is the same as the Micron’s, as well. It is slick and glossy, but fortunately easy to hold, and never once felt like it was slipping in my hand. The cap locks in place firmly and snaps haphazardly onto the back. The clip attached to the cap works das designed. The writing on the body is easy to read and rub resistant, and the identification on the cap is easy to read.

20121102-235932.jpg

 

But now for what this item is about: the brush. The brush is fairly short, no longer than the nib of the regular Microns or most other pens. The brush at its finest is super thin, and goes up to an above average pen thickness. The line range is roughly equivalent to the Micron 005 to 05 and everywhere in between. The application is buttery smooth and never splutters or splatters. Even when the brush begins running out of ink you will only begin to get a grey line instead of a patchy one. And it takes a long time to get it to run out.20121102-235937.jpg

 

For fine detail work this item is perfect, it is a perfect addition to the Pigma family and suits the audience it was created for perfectly. But it is for a specific audience. Very large or multimedia projects will find the product ill suited to create most desired effects. But that does not diminish the fact that it is a very good pen.