Custom LEGO Troop Transport Vehicle

So I was thinking I shout upgrade my LEGO troop transport vehicle. I had made this a few years ago, so it looks kind of, um, crap.


Side view.


The back opens up and can hold 2 minifigures.


Cockpit holds on and has controls.


Gunner postion swivels and has limited armor. Apparently the guns are anti-aircraft, as they can only point up while still being held by the minifig.


Fits 4 minifigs total.

I decided to overhaul the design as the colors were mixed up and the resemblance to a military vehicle is only slight. Here was my first attempt.


Sorry about the finger in the way. The remodel is slightly larger than the original, the side armor is sloped but the integration with the front slope is non-existent and looks ugly in my opinion. The turret is redesigned, with a short barreled cannon and some armor, it rotates fully but has nothing in the back.


The driver has a small gun and the turret is placed slightly to the side as to not interfere with the drivers hatch.


The side armor on either side is different, and the turret (which is my favorite part) extends over the back. There is no room for additional troops.


Round back is nothing special, pieces don’t quite sync up, but that’s my fault.

After this I decided the body was to short, so I remodeled and added some length.


Here you can see how I retained the sloping side armor.


I decided to get rid of this side armor as it looked unrealistic.


Here is my eventually finished product, occupied by a driver and a gunner. I ran out of pieces so I’m not fully satisfied, but I like it.


The driver now has more room and retains his small machine-gun.


The turret is once again moved to the right to prevent interference with the driver position.


The hatch, when fully open is will prevent the turret from spinning, but at when it is angled down slightly like this the turret is freely spinning.


The turret redesign is what I’m most proud of, it has sloping armor on the front and back. It fits one minifig, but unfortunately without any gear.


Hatch at the back.


The back compartment fits two figures, good for black, red is holding onto his gear.


Opened hatch.


The vehicle holds four total. Here are some other shots of the finished product.


(the side armor is my least favorite part, it looks too bulky for me)


Leave a Reply


Get every new post on this blog delivered to your Inbox.

Join other followers:

%d bloggers like this: